Honda CR-V: Information / Devices that Emit Radio Waves

Honda CR-V 2017-2026 Owner's Manual / Information / Devices that Emit Radio Waves

Each radio frequency device installed in the vehicle conforms to the requirements and standards of the regulation listed below:

As required by the FCC:

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Identification Numbers

Vehicle Identification Number (VIN), Engine Number, and Transmission Number Your vehicle has a 17-digit vehicle identification number (VIN) used to register your vehicle for warranty purposes, and for licensing and insuring your vehicle...

Reporting Safety Defects

In the U.S. If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Honda Motor Co...

Other information:

Honda CR-V 2017-2026 Owner's Manual: Scan

Sample each channel on the selected mode for 10 seconds. Select Scan. Select Scan Channels.You can select the desired channel by songs using Scan Song in Preset. To turn off scan, select Cancel. The “Scan Songs in Preset” function is based on TuneScan™ technology of SiriusXM®...

Honda CR-V 2017-2026 Owner's Manual: Changing a Flat Tire. Getting Ready to Replace the Flat Tire

Open the cargo area floor lid. Take the tool bag out of the cargo area.Take the wheel nut wrench and jack handle bar out of the tool bag. Take the jack out of the spare tire area. Unscrew the wing bolt and remove the spacer cone. Then remove the spare tire...