Honda CR-V: Checking and Maintaining Tires / Tire and Wheel Replacement
Replace your tires with radials of the same size, load range, speed rating,
and
maximum cold tire pressure rating (as shown on the tire‘s sidewall). Using tires
of a
different size or construction can cause certain vehicle systems such as the ABS
and
Vehicle Stability Assist™ (VSA®) system to work incorrectly.
It is best to replace all four tires at the same time. If that isn’t
possible, replace the
front or rear tires in pairs.
Make sure that the wheel’s specifications match those of the original wheels.
WARNING
Installing improper tires on your vehicle can
affect handling and stability. This can cause
a crash in which you can be seriously hurt or
killed.
Always use the size and type of tires
recommended in this owner’s manual.
The life of your tires is dependent on many factors, including driving habits,
road
conditions, vehicle loading, inflation pressure, maintenance history, speed, and
environmental conditions (even when the tires are not in use)...
Rotating tires according to the maintenance messages on the driver
information
interface helps to distribute wear more evenly and increase tire life...
Other information:
*1: Models with navigation system
Climate Control On
Climate Control Off
Fan Speed <1-7>
Temperature max heat
Temperature max cool
Temperature <57-87> degrees (U.S.)
Temperature <18-32> degrees (Canada)
Defrost On
Defrost Off
Air conditioner On
Air conditioner Off
More
Vent
Dash and floor
Floor vents
Floor and Defrost
Climate Control Automatic
Fan Speed up/down
Temperature up
Temperature down
NOTE:
These commands toggle the function on
and off, so the command may not match
your intended action...
*: Canadian models only, if equipped
The power mode must be in ON to use the
heated steering wheel.
Press the button on the right side of the
steering wheel.
When a comfortable temperature is reached,
press the button again to turn it off.
The heated steering wheel is turned off every
time you start the engine, even if you turned it
on the last time you drove the vehicle...
Categories

The seat belt system includes an indicator on
the instrument panel to remind the driver or a
front passenger or both to fasten their seat
belts.
If the ignition switch is turned to ON
*1 and
a seat belt is not fastened, a beeper will sound
and the indicator will blink. After a few
seconds, the beeper will stop and the
indicator will come on and remain illuminated
until the seat belt is fastened.
read more