Honda CR-V: Parking Your Vehicle / When Stopped
- Depress the brake pedal firmly.
- With the brake pedal depressed, pull up the electric parking brake
switch slowly,
but fully.
- Move the shift lever from
to .
- Turn off the engine.
- The parking brake and brake system indicator goes off in about 15
seconds.
Always confirm the electric parking brake is set, in particular if you are
parked on an incline.
After shutting off the engine, you may hear certain
noises coming from the vehicle. Here’s the lowdown:
- Noise from Under Vehicle: This noise is caused by
the vacuum pump inside the fuel evaporation
leakage check module (ELCM).
Depending on conditions, the pump will come on for
about 15 minutes about 5 to 10 hours after engine
shutoff. This noise is just normal vehicle operation
and don’t indicate a vehicle problem.
NOTICE
The following can damage the transmission:
- Depressing the accelerator and brake pedals
simultaneously.
- Holding the vehicle in place when facing uphill by
depressing the accelerator pedal.
- Moving the shift lever into
before the vehicle
stops completely.
In extremely cold temperatures, the parking brake
may freeze up if applied. If such temperatures are
expected, do not apply the parking brake but, if
parking on a slope, either turn the front wheels so
they will contact the curb if the vehicle rolls down the
slope or block the wheels to keep the vehicle from
moving. If you do not take either precaution, the
vehicle may roll unexpectedly, leading to a crash.
WARNING
The vehicle can roll away if left unattended
without confirming that Park is engaged.
A vehicle that rolls away could cause a crash
resulting in serious injury or death...
* Not available on all models
Monitors the rear corner areas using the radar sensors when reversing, and
alerts
you if a vehicle approaching from a rear corner is detected...
Other information:
After adjusting a front seat to the proper position, and while sitting
upright and well
back in the seat:
Pull the seat belt out slowly.
Insert the latch plate into the buckle, then
tug on the belt to make sure the buckle is
secure.
Make sure that the belt is not twisted or
caught on anything...
Adjusting the Clock
Models without navigation system
You can adjust the time in the clock display with the ignition switch in ON
*1.
*1: Models with the smart entry system have an ENGINE START/STOP
button instead of an
ignition switch.
The clock is automatically updated through the navigation system, so the time
does not need to be adjusted...