Honda CR-V: ENGINE START/STOP Button* / Automatic Power Off
If you leave the vehicle for 30 to 60 minutes with the shift lever in
and the power
mode in ACCESSORY, the vehicle automatically goes into the mode similar to
VEHICLE OFF (LOCK) to avoid the battery drain.
Canadian models
When in this mode:
The steering wheel does not lock.
You cannot lock or unlock doors with the remote transmitter or the smart entry system.
Press the ENGINE START/STOP button three times to switch the mode to VEHICLE OFF (LOCK).
If the power mode does not change from VEHICLE OFF to ACCESSORY, press the ENGINE START/STOP button while moving the steering wheel left and right. The steering wheel will unlock, allowing the mode to change.
Do not leave the power mode in ACCESSORY or ON when you get out.
Automatic Power Off
If you leave the vehicle for 30 to 60 minutes with the shift lever in
and
the power
mode in ACCESSORY, the vehicle automatically goes into the mode similar to
VEHICLE OFF (LOCK) to avoid the battery drain...
Other information:
Honda CR-V 2017-2026 Owner's Manual: Shift Lever Does Not Move
Follow the procedure below if you cannot move the shift lever out of the position. Releasing the Lock Set the parking brake. Models without smart entry systemRemove the key from the ignition switch. Models with smart entry system Remove the built-in key from the smart entry remote...
Honda CR-V 2017-2026 Owner's Manual: If the Smart Entry Remote Battery is Weak
Models with smart entry system If the beeper sounds and the To Start, Hold Remote Near Start Button message appears on the driver information interface; and the ENGINE START/STOP button flashes and the engine will not start. Start the engine as follows: Touch the center of the ENGINE START/ STOP button with the H logo on the smart entry remote while the ENGINE START/STOP button is flashing...
Categories
- Manuals Home
- Honda CR-V Owners Manual
- Honda CR-V Service Manual
- Oil Check
- To rapidly defrost the windows
- Front Seats
- New on site
- Most important about car
Seat Belt Reminder
The seat belt system includes an indicator on the instrument panel to remind the driver or a front passenger or both to fasten their seat belts.
If the ignition switch is turned to ON
*1 and
a seat belt is not fastened, a beeper will sound
and the indicator will blink. After a few
seconds, the beeper will stop and the
indicator will come on and remain illuminated
until the seat belt is fastened.
