Honda CR-V: Engine Does Not Start / If the Smart Entry Remote Battery is Weak
Models with smart entry system
If the beeper sounds and the To Start, Hold Remote Near Start
Button message
appears on the driver information interface; and the ENGINE START/STOP
button
flashes and the engine will not start. Start the engine as follows:
- Touch the center of the ENGINE START/
STOP button with the H logo on the smart
entry remote while the ENGINE START/STOP button is flashing.
The
buttons on the smart entry remote
should be facing you.
- The ENGINE START/STOP button
flashes for about 30 seconds.

- Depress the brake pedal and press the
ENGINE START/STOP button within 10
seconds after the beeper sounds and the
ENGINE START/STOP button changes
from flashing to on.
- If you don’t depress the pedal, the mode
will change to ACCESSORY.

If the engine does not start, check the starter.
If you must start the vehicle immediately, use an
assisting vehicle or booster battery to jump start it...
Models with smart entry system
The ENGINE START/STOP button may be used to stop the engine due to an
emergency situation even while driving. If you must stop the engine, do either
of the
following operations:
Press and hold the ENGINE START/STOP button for about two
seconds...
Other information:
Your vehicle is equipped with head restraints in all seating positions.
Adjusting the Front Head Restraints
Head restraints are most effective for
protection against whiplash and other rear-
impact crash injuries when the center of the
back of the occupant's head rests against the
center of the restraint...
The front airbags are housed in the center of the steering wheel for the
driver, and
in the dashboard for the front passenger. Both airbags are marked SRS AIRBAG.
During a frontal crash severe enough to cause one or
both front airbags to deploy, the airbags can inflate
at different rates, depending on the severity of the
crash, whether or not the seat belts are latched, and/
or other factors...
Categories

The seat belt system includes an indicator on
the instrument panel to remind the driver or a
front passenger or both to fasten their seat
belts.
If the ignition switch is turned to ON
*1 and
a seat belt is not fastened, a beeper will sound
and the indicator will blink. After a few
seconds, the beeper will stop and the
indicator will come on and remain illuminated
until the seat belt is fastened.
read more