Honda CR-V: Maintenance Under the Hood / Oil Check
We recommend that you check the engine oil level every time you refuel.
Park the vehicle on level ground.
Wait approximately three minutes after turning the engine off before you
check the
oil.
- Remove the dipstick (orange).
- Wipe the dipstick with a clean cloth or
paper towel.
- Insert the dipstick back all the way into its
hole.

- Remove the dipstick again, and check the
level. It should be between the upper and
lower marks. Add oil if necessary.

If the oil level is near or below the lower mark, slowly
add oil, being careful not to overfill.
Under certain driving conditions, it is normal for the
engine oil level to rise above the upper mark. If you
have a concern, consult a dealer for details.
Honda Genuine Motor Oil
Premium-grade 0W-20 detergent oil with an API Certification Seal on
the
container.
Oil is a major contributor to your engine's
performance and longevity...
Unscrew and remove the engine oil fill cap.
Add oil slowly.
Reinstall the engine oil fill cap, and tighten
it securely.
Wait for three minutes and recheck the
engine oil dipstick...
Other information:
Carbon Monoxide Gas
The engine exhaust from this vehicle contains carbon monoxide, a colorless,
odorless, and highly toxic gas. As long as you properly maintain your vehicle,
carbon monoxide gas will not get into the interior.
Have the exhaust system inspected for leaks whenever
The exhaust system is making an unusual noise...
The immobilizer system prevents a key that has not been pre-registered from
starting the engine. Each key contains electronic transmitters that use
electronic
signals to verify the key.
Pay attention to the following when inserting the key into the ignition
switch * or
pressing the ENGINE START/STOP button * :
Do not allow objects that emit strong radio waves near the ignition switch *
or the
ENGINE START/STOP button * ...
Categories

The seat belt system includes an indicator on
the instrument panel to remind the driver or a
front passenger or both to fasten their seat
belts.
If the ignition switch is turned to ON
*1 and
a seat belt is not fastened, a beeper will sound
and the indicator will blink. After a few
seconds, the beeper will stop and the
indicator will come on and remain illuminated
until the seat belt is fastened.
read more