Honda CR-V: Road Departure Mitigation (RDM) System / RDM On and Off

Honda CR-V 2017-2026 Owner's Manual / Driving / When Driving / Road Departure Mitigation (RDM) System / RDM On and Off

Press the RDM button to turn the system on and off.

The indicator in the button comes on and the message appears on the driver information interface when the system is on.

Honda CR-V. RDM On and Off

When you have selected Warning Only from the customized options using the driver information interface * or the audio/information screen * , the system does not operate the steering wheel and braking.

* Not available on all models

The indicators for the Adaptive Cruise Control (ACC) with Low Speed Follow, Road Departure Mitigation (RDM), Vehicle Stability Assist™ (VSA®) system, Vehicle Stability Assist™ (VSA®) OFF, low tire pressure/TPMS, Collision Mitigation Braking System™ (CMBS™ ), and Parking Brake and Brake System (Amber) may come on along with a message in the Driver Information Interface after reconnecting the battery. Drive a short distance at more than 12 mph (20 km/h). The indicator should go off. If it does not, have your vehicle checked by a dealer.

How the System Activates

The system becomes ready to start searching for lane markings when all the following conditions are met: The vehicle is traveling between about 45 and 90 mph (72 and 145 km/h)...

RDM Conditions and Limitations

The system may not properly detect lane markings and the position of your vehicle under certain conditions. Some examples of these conditions are listed below...

Other information:

Honda CR-V 2017-2026 Owner's Manual: How the System Works

The system activates when: The power mode is in ON. The Cross Traffic Monitor system is turned on. The transmission is in . Your vehicle is moving at 3 mph (5 km/h) or lower. When a vehicle is detected approaching from a rear corner, Cross Traffic Monitor alerts you with a buzzer and a displayed warning...

Honda CR-V 2017-2026 Owner's Manual: Remote Transmitter Care

Replacing the Button Battery If the indicator does not come on when the button is pressed, replace the battery. WARNING CHEMICAL BURN HAZARD The battery that powers the remote transmitter can cause severe internal burns and can even lead to death if swallowed...